综合7
Your Position: Home - Consumer Electronics - What is the Cause of the Crash of the Industrial Touch Monitor?
Guest Posts

What is the Cause of the Crash of the Industrial Touch Monitor?

As an Industrial Touch Monitor Factory, share with you.

Industrial automation replaces the traditional manual industrial chain with basic modern mechanical equipment. The operation of automation equipment cannot be separated from the industrial touch all-in-one machine. The embedded industrial touch all-in-one machine will also experience crashes and common crashes in daily work. what is the reason?

)~28]KHJYJ}PZ[(I$]`{C74.png

In practical applications, users often encounter crashes of industrial touch all-in-one computers, and it is relatively complicated to determine the cause of the crash. Panic is mainly divided into four categories:

01 The parts are of poor quality. CPU, memory stick, graphics card, hard disk, etc. If the quality of the attachment is not good, the computer may not be able to successfully install or install according to the traditional method when installing.

 

02 Poor contact of the bottom plate. The operating system can be installed smoothly. After installing the system, the user finds that the user's device is not available in the system, and can replace the motherboard with another computer, such as serial and keyboard unavailability.

 

03 The motherboard itself has malfunctioned. Due to the components of the motherboard itself, the BIOS self-check may not pass completely after the industrial touch all-in-one host is started, and the IDE and FDD interfaces may not work normally, causing system read and write problems and crashes.

 

04 The host will freeze for 3 or 5 days if it is short, or it will freeze for 3 or 4 months if it is long. This type of problem is the most difficult to find out. It will only hang when the motherboard is tested and not in the user environment. This problem involves the user system, but also the field wiring and the noise immunity of the system. To

 

Faced with these problems, we hope that users can solve the problems from the surrounding environment without shifting the responsibility to the Industrial Touch Monitor.

There are four main reasons for the crash of common industrial touch all-in-ones. Users can judge according to the situation. If the crash is complicated and cannot be solved by the above methods, it is best to contact the manufacturer. Except for experts, it is best not to disassemble the machine for inspection without authorization.

 

Our company also has Industrial Touch Monitor on sale, welcome to contact us.

Comments

0 of 2000 characters used

All Comments (0)
Get in Touch